One of the unique selling points of Xanita board is the ability for the liner to be removed with a heat gun. This allows for clean, quick and easy curves and bends to be created with the board, which adds a new dimension to the design possibilities.
When it comes to volume production there is also a massive time and potential cost saving with not having to resort to multiple parallel cuts to create a curve effect.
*Bends and curves are best created along the length of the board, this is due to the grain of the core running along the width of the board. Think about this when creating your designs.
If you need a portion of the board to retain the liner, you would make use of a surface-cut to allow you to only remove the portion of liner needed.